How to write a professional electrician invoice
Electricians typically charge a service call fee plus hourly labor and marked-up materials, or a flat rate for defined tasks (panel swap, EV charger install, ceiling fan). Hourly billing suits troubleshooting work where the scope is unknown; flat-rate suits installs. The T&M structure below — service call + labor entries + materials with markup — matches how most service electricians invoice.
Typical electrician line items
- Service call
- Labor (hrs)
- Materials & wiring
- Permit & inspection
- Sales tax where applicable (toggle the taxable switch per line item)
- Deposit or partial payment already collected — it is deducted automatically
Example: troubleshoot dead circuit + install GFCI
| Service call / diagnostic fee | $95.00 |
| Labor — trace fault, replace outlet (1.75 hrs @ $110) | $192.50 |
| Materials — 20A GFCI outlet (+20% markup) | $33.60 |
| Subtotal | $321.10 |
| Total due | $321.10 |
Compliance & required info for electrician invoices
- Your electrical license number should appear on the invoice — required in most states for permitted work and expected by commercial clients. [CA CSLB example]
- Panel upgrades, new circuits and EV charger installs usually require a permit and inspection — list the permit fee as its own line.
- If you did work under a permit, note the permit number on the invoice so the customer has it for resale disclosures.
Common electrician invoice mistakes that delay payment
- Billing 'electrical work' as one flat line — itemize diagnostic time, repair labor, and each material
- Charging for the service call AND quoting it as free verbally — put the policy on the invoice
- Forgetting the permit/inspection fee line, which leaves the customer thinking it was skipped
- No license number — the single most common reason commercial clients kick back invoices
Payment terms & tips for electrician
Contractors commonly invoice by progress draw (e.g. 30/40/30 against the contract total) and list change orders as separate lines. Check your state's rules on retainage and always reference the contract or job number.
Add your preferred payment methods (Zelle, check, ACH…) so clients can pay without a follow-up call, and always include a PO or job reference when billing a company — accounting teams reject invoices without one.
Electrician invoice FAQ
How much do electricians charge per hour?
Commonly $50–$130 per hour in the US depending on region, license level (apprentice vs journeyman vs master), and whether it's standard or emergency work. Service call fees of $75–$150 often apply on top.
What's the difference between a service call fee and an estimate fee?
A service call fee is charged for coming out and diagnosing a problem; an estimate fee (when charged) is for quoting new work. Many electricians waive estimate fees but always charge the diagnostic fee.
Do electricians mark up parts?
Yes, typically 10–25% over wholesale cost. This covers sourcing time, warranty handling, and returns. Itemize parts so the markup is defensible if questioned.
Should I separate labor and materials on the invoice?
Always. Property managers, general contractors and warranty companies require it, and several states mandate itemization on repair invoices.
What license info goes on an electrical invoice?
Your electrical contractor license number and classification. Some states also require it on estimates, contracts, and vehicle signage — not just invoices.
How do I bill for troubleshooting that finds no fault?
Charge the diagnostic/service call fee plus actual time spent. Note 'no fault found — system tested' on the invoice so the customer understands what they paid for.