How to write a professional roofer invoice
Roofing prices per 'square' (100 sq ft of roof) for tear-off and install, plus per-linear-foot for flashing/drip edge, and items for underlayment, vents, and permits. Larger jobs bill progress draws (deposit → materials delivered → dry-in → completion); deposits are state-capped in places like California.
Typical roofer line items
- Progress draw payment
- Labor
- Materials & supplies
- Change order / extras
- Sales tax where applicable (toggle the taxable switch per line item)
- Deposit or partial payment already collected — it is deducted automatically
Example: 24 sq re-roof, draw 2 of 2
| Tear-off & disposal (24 sq @ $95) | $2,280.00 |
| Shingle install labor (24 sq @ $140) | $3,360.00 |
| Materials — shingles, underlayment, flashing | $3,120.00 |
| Permit fee (pass-through) | $285.00 |
| Subtotal | $9,045.00 |
| Deposit paid at contract | −$1,000.00 |
| Draw 1 paid at dry-in | −$4,000.00 |
| Total due | $4,045.00 |
Compliance & required info for roofer invoices
- Roofing requires a contractor license in most states — CA requires C-39 for roofing work over $500. [CA CSLB]
- Deposit caps: CA limits home-improvement deposits to the lesser of 10% or $1,000 — check your state's rule before collecting. [CA CSLB]
- Permits are required for re-roofs in most jurisdictions — bill the permit fee as a pass-through line.
Common roofer invoice mistakes that delay payment
- Pricing by roof area without accounting for pitch/stories — steep or high roofs use the difficulty factor legitimately
- No draw schedule on the invoice — multi-day jobs should show deposit and progress payments applied
- Surprise rotten-decking costs — the invoice should reference the per-sheet decking replacement rate agreed in the contract
- Taking a deposit above your state cap — in CA that's a license violation, not just bad practice
Payment terms & tips for roofer
Contractors commonly invoice by progress draw (e.g. 30/40/30 against the contract total) and list change orders as separate lines. Check your state's rules on retainage and always reference the contract or job number.
Add your preferred payment methods (Zelle, check, ACH…) so clients can pay without a follow-up call, and always include a PO or job reference when billing a company — accounting teams reject invoices without one.
Roofer invoice FAQ
How do roofers charge per square?
Per 'square' = 100 sq ft of roof. Tear-off, installation labor, and materials each bill per square — installed costs commonly run $350–$600+ per square for asphalt depending on region and material.
How much deposit can a roofer collect?
State-dependent — CA caps it at 10% or $1,000 (whichever is less) for home improvement. Other states allow more. Check your licensing board's rule.
What should a roofing invoice include?
Squares installed, tear-off and disposal, materials itemized (shingle type, underlayment, flashing), permit fees, draw payments applied, and warranty terms split by material vs workmanship.
How do I bill for rotten decking found during tear-off?
Per-sheet rate agreed in the contract ('decking replacement $X per sheet as needed'), billed as a change-order line with count and photos.
Should roofing bill draws or one final invoice?
Deposit + progress draws is standard for multi-day jobs (deposit → dry-in → completion). One invoice suits single-day repairs. The progress engine tracks the draw schedule.
What's a 'dry-in' payment?
The draw due when the roof is watertight (underlayment on) — commonly the second milestone after deposit. It protects the customer (payment follows progress) and the contractor (not fully exposed until done).